Resource Library

       Typical Properties
        99.95% PLATINUM
          Chemistry Limits per ASTM B561-94 (2005)

Johnson Matthey Rev. 0 September 22, 2006

Chemical Analysis
Platinum	99.95% Min (by difference)
Iridium	150 ppm max
Palladium	200 ppm max
Rhodium	300 ppm max
Ruthenium	100 ppm max
Gold	100 ppm max
Silver	50 ppm max
Other “Base Metal” Elements	As listed in ASTM B561-94 (05)
Physical Properties
Density: Melting Point: Electrical Resistivity	21.45 g/cm³1768 ⁰C 10.6 Microhm-cm at 20 ⁰C
Product Configurations
Wire
CNC machined parts
Seamless tubing
Custom fabrications
Cut tubing
Sheet and ribbon
Spherical powder

Typical Mechanical Properties at Various Conditions at Johnson Matthey

As Drawn

UTS	% Elongation
70KSI	<2%

Stress Relieved

UTS	% Elongation
50-60KSI	>5%

Full Anneal

UTS	% Elongation
22-24KSI	>20%

Tensile data is typical of wire diameters <.010" diameter using 10" gauge length and a strain rate of 1.0 inch per minute.

Please note that the ranges listed above are not for rod stock as typical rod stock sizes are larger than .010" diameter, and are usually tested with a 2" gauge length, and 0.2 inch per minute.

Tensile properties are strongly dependent on the extent of cold work reduction and therefore to some extent on the cross-section of the diameter as well as to a lesser degree on the gauge length of the test sample and the rate of strain when testing.

Values provided are typical of standard production methods. Values beyond those listed are possible for some alloys and product sizes depending on alloy composition by special processing techniques. Please consult our Engineering department for your special requirement applications.

"As-drawn" is defined as characteristic of material that is directly drawn to finish cross-section with no heat treatment applied as a final processing step.
"Stress Relieved" is defined as characteristic of material that has been heat treated after all final cross-section reductions in a temperature range below that which results in full recrystallization of the micro structure.
"Full Anneal" is defined as characteristic of material that has been heat treated as a final processing step above the recrystallization temperature resulting in a complete transition to an equiaxed grain structure.
Please note that typically only chemical composition and mechanical properties are measured for each manufactured lo